UOS News
University of Seoul Research Team Led by Professor Hyeok Kim Develops an Eco-Friendly, Ultra-Low-Power Semiconductor that Uses a Natural Material and Dissolves in Water
– Used natural material gum arabic as a semiconductor insulating layer to enable low-voltage operation
– Achieved a maximum charge mobility of 20.72 cm²/V·s; the insulating layer dissolved within 30 s when immersed in water
– Published in the international journal, Advanced Functional Materials
The University of Seoul announced that a research team led by Professor Hyeok Kim developed an eco-friendly organic thin-film transistor (OTFT) technology that uses natural material gum arabic as a semiconductor insulating layer, which enables water-based processing and low-voltage, high-performance characteristics.
The research team substituted conventional organic solvent-based insulating materials with a natural material (gum arabic) that can be processed using water and achieved high charge mobility even at low voltages of ±3 V. These findings highlight the potential of this approach for sustainable, low-power semiconductor technology.
The use of electronic devices is increasing, owing to which electronic waste is emerging as a new environmental issue. Therefore, in the semiconductor industry, there is an increased focus on the importance of sustainable electronics technology that reduces environmental impact from manufacturing to disposal, in addition to enhancing device performance. Conventional polymer insulators, including silicon oxide, aluminum oxide, and PMMA, often require organic solvents or high process energy for manufacturing. Moreover, they have the limitation of persisting in the environment for extended periods after disposal.
To address these issues, the research team used gum arabic, which is a natural polysaccharide obtained from acacia trees, as the gate-insulating layer in transistors. Gum arabic dissolves readily in water, thereby allowing thin films to be formed from aqueous solutions without requiring organic solvents. By systematically adjusting the concentration of gum arabic, the research team fabricated uniform insulating layers. At a concentration of 30 wt%, the resulting uniform thin film exhibited a low surface roughness of approximately 1.6 nm and visible light transmittance exceeding 90%.
▶Structure, Materials, and Electrical Characteristics of the Fabricated Devices
In particular, the gum arabic insulating layer exhibited a high dielectric constant of approximately 27 at 1 kHz. This was approximately nine times that of the conventional PMMA insulator (approximately 3) used for comparison. An insulating layer with a high dielectric constant can effectively guide charges into a semiconductor channel even at low voltages, which is advantageous for reducing the operating voltage of electronic devices.
The organic thin-film transistor incorporating gum arabic operated stably at a low voltage of ±3 V and recorded an average charge mobility of 8.90 cm²/V·s and a maximum of 20.72 cm²/V·s under the optimized condition of 30 wt%. By contrast, the PMMA-based control device exhibited a charge mobility of approximately 0.2 cm²/V·s when operated at ±20 V. These results indicated the potential of simultaneously achieving low-voltage operation and high charge transport performance using eco-friendly natural materials.
The excellent interfacial properties between gum arabic and the organic semiconductor played a key role in improving the device performance. The smooth surface of the optimized gum arabic film promoted a uniform and regular arrangement of the organic semiconductor DNTT and reduced the interfacial defects that hindered charge transport. The device fabricated with 30 wt% gum arabic exhibited stable charge transport and a lower interfacial trap density than the conventional PMMA-based device.
▶Sequential dissolution process of gum arabic-based OTFTs when immersed in water
This study was significant because it addressed not only semiconductor manufacturing but also the disposal of semiconductors after use. When the fabricated device is immersed in water, the gum arabic insulating layer begins to dissolve after approximately 10 s and dissolves completely within approximately 30 s.
This technology is expected to contribute to the development of next-generation electronic technologies that reduce electronic waste, including transient electronic devices designed for short-term use before being discarded, as well as eco-friendly wearable sensors and single-use electronic devices. In particular, by using water as a processing solvent and enabling low-voltage operation, an approach was developed that could reduce the environmental impact of electronic devices throughout their lifecycle, from manufacturing and use to disposal.
▶ (From left) Researcher Mirinae Lee, Ph.D. candidate Hyo-won Jang, Research Professor Biswas Swarup (co-first authors), and Professor Hyeok Kim (corresponding author)
Professor Hyeok Kim stated, “This research was significant because it used gum arabic, which is a naturally derived material, as a semiconductor-insulating material, thereby enabling an eco-friendly aqueous process and low-voltage, high-performance device characteristics.” He added, “Although conventional electronic devices have been developed with an emphasis on performance improvements, sustainable semiconductor technology that considers the entire lifecycle from manufacturing to end-of-life disposal will become increasingly important in the future.” He continued, “We plan to further develop the materials and device structures in order to expand their applications to various low-power electronic systems, including eco-friendly wearable sensors and transient electronic devices.”
The research findings were published in Advanced Functional Materials, which is a leading international journal in materials science, as an article titled “Water-Processed Gum Arabic Dielectric for Low-Voltage, High-Mobility, and Transient Organic Thin-Film Transistors.” University of Seoul researchers Mirinae Lee, Hyo-won Jang, and Swarup Biswas are the co-first authors, and Professor Hyeok Kim is the corresponding author of the paper.
This research was supported by the Ministry of Science and ICT and the National Research Foundation of Korea under the Mid-Career Researcher Support Program and Global Basic Research Laboratory Support Program (Advanced Type). It was also supported by the Ministry of Trade, Industry and Energy and the Korea Institute for Industrial Technology Planning and Evaluation (KEIT) under the Semiconductor Advanced Strategic Industry Leapfrog Technology Development Project. It received infrastructure support from the Semiconductor Research Center (UOS Fab) of the University of Seoul.








